Abdichtung unter Steinteppich mit MARIS Mariseal 460 und TECHPUR Systemvlies

Stone carpet on balcony & terrace: What kind of waterproofing do I need?

A stone carpet is open-pored: rainwater drains downward through the covering. To ensure that this water does not penetrate the substrate and cause moisture or frost damage, we generally recommend waterproofing under the stone carpet for balconies, terraces, and other exposed areas. In this guide, you will learn which options are available and how the waterproofing is structured.

Important to know

The waterproofing is not included in our complete stone carpet sets because the correct structure depends on the substrate and the structural conditions. It can be ordered separately – if you have any questions about your project, we are happy to advise you personally at +43 7488 21300.

Where does the waterproofing go?

The waterproofing is located between the primer and the stone carpet. The structure from bottom to top:

  1. prepared substrate (sanded and vacuumed)
  2. primer, e.g., MARIS Mariseal 710
  3. waterproofing with system fleece
  4. quartz sand, broadcast into the final fresh waterproofing layer
  5. stone carpet made of marble gravel and binder

Also important for outdoor areas: a gradient of at least 2% so that water drains reliably and no standing water (waterlogging) occurs.

Three variants: without, with, and with ETAG waterproofing

1. Without waterproofing

If no waterproofing is used, this work step is omitted: the quartz sand is broadcast directly into the fresh primer. We do not recommend this variant for exposed areas such as balconies and terraces.

2. With waterproofing

For balconies and terraces, we use the aliphatic PU waterproofing MARIS Mariseal 460 with a consumption of approx. 1.0–1.5 kg/m²:

  • Thoroughly stir the waterproofing in the bucket using a mixing paddle and apply it evenly.
  • Embed the TECHPUR system fleece in the corners and at the wall connection (upstand).
  • Broadcast the quartz sand before it dries.
  • Allow to dry for about 12–24 hours (depending on weather conditions).

3. With ETAG waterproofing – if living space is located underneath

ETAG waterproofing is required if there is living space underneath the area. The application is basically the same; the difference lies in the material consumption and the structure with a fleece inlay – a total of approx. 3 kg/m² of Mariseal 460:

  • apply approx. 1.5 kg/m² of waterproofing evenly
  • embed system fleece as well as inner and outer corners
  • apply another layer of approx. 1 kg/m²
  • after drying, apply a final layer of approx. 0.5 kg/m² and broadcast the quartz sand
  • allow to dry for about 24 hours (depending on weather conditions)

Material list for the waterproofing

You can find more waterproofing products in our category Balcony & Terrace.

What else you should pay attention to

  • Glue edge profiles at points: Point fastening allows the stone carpet to drain downward. Please contact our support for the correct installation of balcony edge profiles.
  • Sealing in outdoor areas: A pore sealer closes the open pores – water can then no longer drain through the covering. In this case, a sufficient gradient and a well-draining substrate structure are particularly important; standing water must be avoided.
  • Frost resistance: A professionally installed stone carpet is frost- and weather-resistant – provided that water can drain away unimpeded.

Stone carpet for balcony & terrace

You can get marble gravel, binder, primer, quartz sand, and smoothing agent in the complete stone carpet set for outdoor areas – with a consumption calculator for your area. The complete step-by-step instructions including waterproofing can be found in the instructions for outdoor areas (PDF).

Further guides

Back to blog